Wireless Security Commands; Table 25: Wireless Security Commands - SMC Networks EliteConnect SMCE21011 User Manual

27
auth
W S
IRELESS
The commands described in this section configure parameters for wireless
security on the 802.11a and 802.11g interfaces.

Table 25: Wireless Security Commands

Command Function
auth Defines the 802.11 authentication type
allowed by the access point
encryption Defines whether or not WEP encryption is
used to provide privacy for wireless
communications
key Sets the keys used for WEP encryption
transmit-key Sets the index of the key to be used for
encrypting data frames sent between the
access point and wireless clients
cipher-suite Selects an encryption method for the global
key used for multicast and broadcast traffic
wpa-pre-shared- key Defines a WPA preshared-key value
pmksa-lifetime Sets the lifetime PMK security associations
make-security
effective
This command configures authentication for the VAP interface.
S
YNTAX
auth <open-system | shared-key | wpa | wpa-psk | wpa2 |
wpa2-psk | wpa-wpa2-mixed | wpa-wpa2-psk-mixed | >
open-system - Accepts the client without verifying its identity
using a shared key. "Open" authentication means either there is no
encryption (if encryption is disabled) or WEP-only encryption is used
(if encryption is enabled).
shared-key - Authentication is based on a shared key that has
been distributed to all stations.
wpa - Clients using WPA are accepted for authentication.
wpa-psk - Clients using WPA with a Pre-shared Key are accepted
for authentication.
wpa2 - Clients using WPA2 are accepted for authentication.
wpa2-psk - Clients using WPA2 with a Pre-shared Key are
accepted for authentication.
– 218 –
C
ECURITY OMMANDS
Mode Page
IC-W- 221
VAP
IC-W- 220
VAP
IC-W 221
IC-W- 222
VAP
IC-W- 222
VAP
IC-W- 224
VAP
IC-W- 224
VAP
IC-W- 225
VAP