Invalid Attachment Reasons And Actions - HP StorageWorks Edge Switch 2/12 Service Manual

21
The attached device is causing the recurrent link incident or No Light message.
Notify the customer of the problem and have the system administrator:
1. Inspect and verify operation of the attached device.
2. Repair the attached device if a failure is indicated.
3. Monitor port operation for approximately five minutes.
Did a link incident or No Light message recur?
YES
↓
Contact the next level of support. Exit MAP.
22
The switch port reporting the problem is causing the recurrent link incident or No
Light message. The recurring problem indicates port degradation and a possible
pending failure. Go to
23
As indicated by a message or event code 081, a port has an invalid attachment.
The information in the Port Properties dialog box specifies the reason, as listed
in Table
Table 10: Invalid Attachment Reasons and Actions
Unknown
ISL connection not allowed.
Incompatible switch.
External loopback plug connected.
N-Port connection not allowed.
Non-HP M-series switch at other end.
Unauthorized port binding WWN.
Unresponsive node.
Fabric binding mismatch.
Edge Switch 2/12 Service Manual
NO
The attached device, Fibre Channel link, and switch appear
operational. Exit MAP.
step 21.
10.
Reason Action
Contact the next level of support.
Go to step 24.
Go to step 25.
Go to step 26.
Go to step 24.
Go to step 25.
Go to step 12.
Go to step 28.
Go to step 31.
Diagnostics
67