HP StorageWorks Edge Switch 2/12 Service Manual page 50

Diagnostics
2. At the Netsite field (Netscape Navigator) or Address field (Internet
3. Type the user name and password obtained in
Does the EWS interface appear operational with the View panel displayed?
NO
↓
6
A problem with another LAN-attached device may be indicated.
Did repair of an unrelated LAN-attached device solve the problem?
NO
↓
7
The IP address defining the switch to the Ethernet LAN must be verified. A
maintenance terminal (PC) and asynchronous RS-232 null modem cable are
required to verify the switch IP address. The tools are provided with the switch or
by service personnel. To verify the IP address:
1. Remove the protective cap from the 9-pin maintenance port at the rear of the
2. Connect the other cable end to a 9-pin communication port (COM1 or
3. Power on the maintenance terminal. After the PC powers on, the Windows
50
Explorer), type http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the IP address of the switch (obtained in
0000: Start MAP" on page 32). A username and password entry dialog box
appears.
page 32, and click OK. If the View panel does not display, wait five minutes
and perform this step again.
YES
The switch-to-EWS PC connection is restored and appears
operational. Exit MAP.
If the problem is associated with another switch or server, go to
Start MAP" on page 32 to isolate the problem for that device. Exit MAP.
If the problem is associated with an unrelated device, notify the customer and
have the system administrator correct the problem.
YES
The switch-to-EWS PC connection is restored and appears
operational. Exit MAP.
switch (a phillips-tip screwdriver may be required). Connect the RS-232 null
modem cable to the port.
COM2) at the rear of the maintenance terminal PC.
desktop displays.
"MAP
"MAP 0000: Start MAP" on
"MAP 0000:
Edge Switch 2/12 Service Manual