HP StorageWorks Edge Switch 2/12 Service Manual page 145

Table 32: Event Code 081 (Continued)
B = Unresponsive node–The attached node did not respond, resulting in a G_Port
ELP timeout. Check the status of the attached device and clean the link's fiber-optic
components (cable and connectors). If the problem persists, contact support
personnel to report the problem.
C = ESA security mismatch–Processing of the Exchange Security Attribute (ESA)
frame detected a security feature mismatch. The fabric binding and switch binding
parameters for this switch and the attached fabric element must agree. At the
Fabric Binding and Switch Binding–State Change dialog boxes, ensure the
parameters for both fabric elements are compatible, or disable the fabric and
switch binding features.
D = Fabric binding mismatch–Fabric binding is enabled and an attached fabric
element has an incompatible fabric membership list. At the Fabric Binding dialog
box, update the fabric membership list for both fabric elements to ensure
compatibility, or disable the fabric binding feature.
E = Authorization failure reject–The fabric element connected to the switch through
an ISL detected a security violation. As a result, the switch received a generic
reason code and set the port to an invalid attachment state. Check the port status of
the attached fabric element and clean the link's fiber-optic components (cable and
connectors). If the problem persists, contact support personnel to report the
problem.
F = Unauthorized switch binding WWN–Switch binding is enabled and an
attached device or fabric element has an incompatible switch membership list. At
the Switch Binding–Membership List dialog box, update the switch membership list
for the switch and the attached device or fabric element to ensure compatibility, or
disable the switch binding feature.
11 = Fabric mode mismatch–Based on the ELP revision level, a connection was not
allowed because an HP switch in legacy mode is attached to an HP switch in Open
Fabric mode, or an HP switch in Open Fabric mode is attached to an OEM switch
at an incorrect ELP revision level. Update the fabric mode for one switch using the
Interop Mode drop-down list at the Configure Fabric Parameters dialog box.
12 = CNT WAN extension mode mismatch–Based on switch-to-switch differences
between the ELP maximum frame sizes allowed, a connection was not allowed to a
switch set to Computer Network Technologies (CNT) wide area network (WAN)
extension mode. CNT firmware is not currently supported by HP.
Distribution: Switch
EWS
Event
Log
Edge Switch 2/12 Service Manual
HAFM Appliance
System Event
Error Log
LED
E-Mail Call
Home
Event Codes
Host
Sense Link
Info Incident
145