HP StorageWorks Edge Switch 2/12 Service Manual page 39

18
Obtain event codes from the EWS Event Log.
Note:
Record the date, time, and listed sequence, and determine if the codes are related to
the reported problem. Begin fault isolation with the most recent event code with the
highest severity level. Other codes may accompany this event code, or may indicate a
normal indication after a problem is resolved.
1. At the View panel, select Monitor at the left side of the panel. The Monitor
2. Click the Log tab. The Log page displays
Figure 9: Monitor panel (Log page)
3. Record the event code, date, time, and severity (Informational, Minor, Major,
4. Record all event codes that may relate to the reported problem.
Were one or more event codes found?
NO
↓
Return to
step, contact the next level of support. Exit MAP.
Edge Switch 2/12 Service Manual
If multiple event codes are found, note all codes and associated severity levels.
panel opens with the Port List page displayed.
or Severe).
YES
Go to Table 4
step 1 and perform fault isolation again. If this is the second time at this
(Figure
on page 28 to interpret event codes. Exit MAP.
Diagnostics
9).
39