HP StorageWorks Edge Switch 2/12 Service Manual page 104

Repair Information
6. Type the port number to be tested in the Targeted Port Number field.
7. At the Diagnostics Test list box, select the External Loopback option.
8. Click Start Port Diagnostics. The test begins and:
Note:
9. When the test completes, results appear as Passed or Failed in the
10. Remove the loopback plug and reconnect the fiber-optic jumper cable from
11. Reset the tested port:
12. Notify the customer the test is complete and the device can be reconnected to
104
a. The Start Port Diagnostics button changes to a Terminate Port
Diagnostics button.
b. The message Diagnostics Time Remaining: xx appears, where
xx are the seconds remaining in the test. The test takes approximately 30
seconds.
Click Terminate Port Diagnostics at any time to abort the loopback test.
message area of the dialog box.
the device to the port (disconnected in
a. Click the Reset tab. The Port page displays with the Reset tab selected.
b. For the tested port, click (enable) the check box in the Port Reset column.
A check mark in the box indicates the port reset option is enabled.
c. Click Activate at the bottom of the page. The port resets and the message
Your changes have been successfully activated
appears.
the switch and set online.
step 2).
Edge Switch 2/12 Service Manual