HP StorageWorks Edge Switch 2/12 Service Manual page 75

37
Install the Flexport Technology feature key. Refer to the HP StorageWorks Edge
Switch 2/12 Installation Guide for more information.
Did installation of the key solve the problem?
NO
↓
38
A transmission speed conflict between the port configuration and the SFP optical
transceiver is indicated.
1. At the EWS interface View panel, select Configure at the left side of the
2. At the Speed column, click the arrow adjacent to the list box for the port and
3. Click Activate to save the change. The message Your changes to the
Did reconfiguring the port speed solve the problem?
NO
↓
Contact the next level of support. Exit MAP.
39
A switch port state indicates No Light because a Fibre Channel device is not
attached to the port, or a problem exists with the fiber-optic cable, attached
device, or SFP optical transceiver.
Is a Fibre Channel device connected to the port?
NO
↓
Edge Switch 2/12 Service Manual
YES
The switch appears operational. Exit MAP.
panel. The Configure panel opens with the Ports page displayed.
select a port speed as follows:
— Select 1 Gb/sec if a one gigabit per second (Gbps) optical transceiver is
installed in the port.
— Select 2 Gb/sec if a two Gbps optical transceiver is installed in the port.
Port Configuration have been successfully activated
appears.
YES
The switch appears operational. Exit MAP.
YES
Go to step 42.
Diagnostics
75