HP StorageWorks Edge Switch 2/12 Service Manual page 88

Diagnostics
24
A zone merge process failed during ISL initialization. The following list explains
the reason:
Disconnect the fiber-optic jumper cable from the E_Port reporting the problem,
then reconnect the cable to the same port.
Did disconnecting and reconnecting the cable solve the problem and was the
resulting zone merge process successful?
NO
↓
Perform the procedure described in
Contact the next level of support. Exit MAP.
25
A zone merge process failed during ISL initialization. The following list explains
the reason:
Obtain supplementary error code data for the 150 event code. At the EWS Event
Log, examine bytes 12 through 15 of event data that specify the error code.
Record the error code and supplementary error code data.
Perform the procedure described in
Contact the next level of support, and report the 150 event code, the associated
failure reason, and the associated error code. Exit MAP.
88
Failure reason 01 - An invalid data length condition caused an error in a zone
merge frame.
Failure reason 08 - An invalid zone set format caused an error in a zone merge
frame.
Failure reason F0 - A retry limit reached condition caused an error in a zone
merge frame.
Failure reason F1 - An invalid response length condition caused an error in a
zone merge frame.
Failure reason F2 - An invalid response code caused an error in a zone merge
frame.
YES
The merged zone appears operational. Exit MAP.
Failure reason 09 - Invalid data caused a zone merge failure.
Failure reason 0A - A Cannot Merge condition caused a zone merge
failure.
"Collect Maintenance Data" on page 105
"Collect Maintenance Data" on page 105
Edge Switch 2/12 Service Manual
.
.