HP StorageWorks Edge Switch 2/12 Service Manual page 82

Diagnostics
6. Type the recommended E_D_TOV and R_A_TOV values, then click
7. Repeat
8. Set both switches online. Refer to
Did the operating parameter change solve the problem and did both switches join
through the ISL to form a fabric?
NO
↓
Contact the next level of support. Exit MAP.
14
A switch E_Port segmented because two fabric elements had duplicate domain
IDs.
1. Work with the system administrator to determine the desired domain ID (1
2. Notify the customer both switches will be set offline. Ensure the system
3. Set both switches offline. Refer to
4. At the View panel, select Configure at the left side of the panel. The
5. Click the Switch tab, then click the Parameters tab. The Parameters page
6. Type the customer-determined preferred domain ID value, then click
7. Repeat
82
Activate to save the change. The message Your changes to the
fabric parameters configuration have been
successfully activated appears.
step 4 through
(second switch). Use the same E_D_TOV and R_A_TOV values.
page 107.
YES
The switch, associated ISL, and multiswitch fabric appear
operational. Exit MAP.
through 31 inclusive) for each switch.
administrator quiesces Fibre Channel frame traffic through the switches and
sets attached devices offline.
page 107.
Configure panel opens with the Ports page displayed.
displays.
Activate to save the change. The message Your changes to the
Operating Parameters configuration have been
successfully activated appears.
step 4 through
(second switch). Use a different preferred domain ID value.
step 6 for the switch attached to the segmented E_Port
"Set the Switch Online or
"Set the Switch Online or
step 6 for the switch attached to the segmented E_Port
Offline" on
Offline" on
Edge Switch 2/12 Service Manual