HP StorageWorks Edge Switch 2/12 Service Manual page 37

2. Disable port beaconing at the EWS interface:
Continue to the next step.
13
At the View panel, does the Operational State field display a Segmented
message?
NO
↓
14
At the View panel, does the Operational State field display a message indicating
a port problem?
NO
↓
15
Repeat
problem is suspected (ports 0 through 11).
Is a problem indicated for any of the ports?
NO
↓
Edge Switch 2/12 Service Manual
a. At the View panel, select Operations at the left side of the panel. The
Operations panel opens with the Switch and Beacon pages displayed.
b. Click the Port tab. The Operations panel opens with the Port and
Beacon pages displayed.
c. Click the check box (checked) in the Beaconing State column and click
Activate to remove the check mark and disable beaconing. The message
Your changes have been successfully activated
appears.
YES
Port segmentation is indicated. Go to
no event codes are found, go to
Segmented Port Problem
YES
Go to step 18
"MAP 0500: Port Failure and Link Incident
Exit MAP.
step 11 through step 14
YES
Go to step 18
"MAP 0500: Port Failure and Link Incident
Exit MAP.
"MAP 0600: Fabric, ISL, and
Determination" on page 76. Exit MAP.
to obtain event codes. If no event codes are found, go to
for each remaining Fibre Channel port for which a
to obtain event codes. If no event codes are found, go to
step 18 to obtain event codes. If
Analysis" on page 59.
Analysis" on page 59.
Diagnostics
37