HP StorageWorks Edge Switch 2/12 Service Manual page 73

4. Click Save and Activate to save and activate the displayed fabric binding
Did updating the fabric binding membership lists solve the problem?
NO
↓
Contact the next level of support. Exit MAP.
32
A port connection is not allowed because of a switch binding mismatch between
fabric elements. Switch membership lists must be compatible for both switches.
At the EWS interface for both switches:
1. At the View panel, select Configure at the left side of the panel. The
2. Click the Security tab, then click the Switch Binding tab. The Switch
3. The Attached Nodes drop-down list contains the world wide names of
4. Click Submit. A confirmation dialog box appears. Click OK to close the
Did updating the switch binding membership lists solve the problem?
NO
↓
Contact the next level of support. Exit MAP.
Edge Switch 2/12 Service Manual
configuration. A confirmation dialog box appears. Click OK to close the
confirmation dialog box, activate the fabric binding configuration, and change
the status to Saved & Active.
YES
The switch appears operational. Exit MAP.
Configure panel opens with the Ports page displayed.
Binding page displays.
attached Fibre Channel devices. Ensure these switch binding membership lists
are compatible for both switches
— To add a member (node or device) to the switch binding membership list
displayed at the bottom of the page, select a WWN from the Attached
Nodes drop-down list and click the adjacent Add Member button; or
type a new WWN in the Detached Node (WWN) field and click the
adjacent Add Member button.
— To delete a device from the switch binding membership list, click the
Delete button adjacent to the device WWN. A confirmation dialog box
appears. Click OK to close the dialog box and delete the device.
confirmation dialog box, activate the selected connection policy, and change
the switch binding state.
YES
The switch appears operational. Exit MAP.
Diagnostics
73