HP StorageWorks Edge Switch 2/12 Service Manual page 84

Diagnostics
16
A switch E_Port segmented because a build fabric protocol error was detected.
1. Disconnect the fiber-optic jumper cable from the segmented E_Port.
2. Reconnect the cable to the same port.
Did disconnecting and reconnecting the cable solve the problem and did both
switches join through the ISL to form a fabric?
NO
↓
17
Initial machine load (IML) the switch. Refer to
page 114.
Did the IML solve the problem and did both switches join through the ISL to form
a fabric?
NO
↓
Perform the data collection procedure and contact the next level of support. Exit
MAP.
18
A switch E_Port segmented because no switch in the fabric is capable of
becoming the principal switch.
1. Notify the customer the switch will be set offline. Ensure the system
2. Set the switch offline. Refer to
3. At the View panel, select Configure at the left side of the panel. The
84
YES
The switch, associated ISL, and multiswitch fabric appear
operational. Exit MAP.
YES
The switch, associated ISL, and multiswitch fabric appear
operational. Exit MAP.
administrator quiesces Fibre Channel frame traffic through the switch and sets
attached devices offline.
page 107.
Configure panel opens with the Ports page displayed.
"IML or Reset the
"Set the Switch Online or
Edge Switch 2/12 Service Manual
Switch" on
Offline" on