Syslog, Cdr And Debug Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Test Call Rules
configure troubleshoot
>test-call test-call-table
[Test_Call]

72.3.3 Syslog, CDR and Debug Parameters

The Syslog, CDR and debug parameters are described in the table below.
Parameter
Enable Syslog
configure troubleshoot >
syslog > syslog
[EnableSyslog]
Syslog Server IP
configure troubleshoot >
syslog > syslog-ip
[SyslogServerIP]
Syslog Server Port
configure troubleshoot >
syslog > syslog-port
[SyslogServerPort]
CDR Server IP Address
configure troubleshoot > cdr >
cdr-srvr-ip-adrr
[CDRSyslogServerIP]
Version 7.2
Defines Test Call rules.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupName,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SIPInterfaceName, Test_Call_ApplicationType,
Test_Call_AutoRegister, Test_Call_UserName, Test_Call_Password,
Test_Call_CallParty, Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For more information, see 'Configuring Test Call Endpoints' on page
1035.
Table 72-20: Syslog, CDR and Debug Parameters
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.

[0] Disable (default)

[1] Enable
Note:

If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).

Syslog messages may increase the network traffic.

To configure Syslog SIP message logging levels, use the
GwDebugLevel parameter.

By default, logs are also sent to the RS-232 serial port. For how
to establish serial communication with the device, refer to the
Installation Manual.
Defines the IP address (in dotted-decimal notation) of the computer
on which the Syslog server is running. The Syslog server is an
application designed to collect the logs and error messages
generated by the device.
The default IP address is 0.0.0.0.
Defines the UDP port of the Syslog server.
The valid range is 0 to 65,535. The default port is 514.
Defines the destination IP address to where CDR logs are sent.
The default value is a null string, which causes CDR messages to be
sent with all Syslog messages to the Syslog server.
Note:
72. Configuration Parameters Reference
Description
Description
1085 Mediant 800B Gateway & E-SBC