Endress+Hauser PROline Prosonic Flow 93 Function Manual page 152

3 Transducer Blocks (transmission blocks)
152
"TRANSDUCER_TOT" (E+H parameters) / base index 1550
Parameter Write access
with operating
mode
(MODE_BLK)
Totalizer 2 - AUTO - OOS
Assign
Totalizer 2 - AUTO - OOS
Mode
Totalizer 2 - AUTO - OOS
Reset
PROline Prosonic Flow 93 FOUNDATION Fieldbus
Description
For assigning a measured variable to the totalizer.
Options:
OFF
VOLUME FLOW CH1
VOLUME FLOW CH2
VOLUME FLOW AVERAGE
VOLUME FLOW SUM
VOLUME FLOW DIFF.
Factory setting:
VOLUME FLOW CH1


Note!
The totalizer is reset to "0" as soon as the selection is changed.
Use this parameter to define how the flow components are to be
totalled by the totalizer.
Options:
BALANCE
Positive and negative flow components. The positive and negative
flow components are balanced. In other words, net flow in the flow
direction is registered.
FORWARD
Positive flow components only
REVERSE
Negative flow components only
Factory setting:
FORWARD
Resets totalizer 2 ("Totalizer 2 - System Value" parameter, see
Page 151) to zero.
Options:
NO
YES
Factory setting:
NO


Note!
Resetting of the totalizer can be also be controlled or initiated using
cyclic data transmission via the Discrete Output function block,
(see Page 181).
Endress+Hauser