Endress+Hauser PROline Prosonic Flow 93 Function Manual page 123

PROline Prosonic Flow 93 FOUNDATION Fieldbus
Endress+Hauser
"TRANSDUCER_CH1" and "TRANSDUCER_CH2" (E+H parameters) /
Parameter Write access
with operating
mode
(MODE_BLK)
Sensor Param. - AUTO - OOS
Sensor Type
3 Transducer Blocks (transmission blocks)
Base index 1200 and 1300
Description


Note!
This parameter is only active if "OFF" was not selected in the
"Sensor Param. - Measurement" parameter.
Sensor type selection. The options in this parameter depend on
the measurement method selected in the "Sensor Param. -
Measurement" parameter, (see Page 122).
Options:
(if "CLAMP ON" was selected in the "Sensor Param. -
Measurement" parameter)
W-CL-05F-L-B
W-CL-1F-L-B
W-CL-2F-L-B
P-CL-05F-L-B
P-CL-1F-L-B
P-CL-2F-L-B
P-CL-05F-M-B
P-CL-1F-M-B
P-CL-2F-M-B
U-CL-2F-L-A
Options:
(if "INSERTION" was selected in the "Sensor Param. -
Measurement" parameter)
W-IN-1F-L-B
Factory setting:
W-CL-2F-L-B


Caution!
Although the following options also appear in this parameter, they
can only be selected by means of the local display (see Page 64)
or the configuration and service software FieldTool:
• P-CL-1S-L-B
• P-CL-1S-M-B
• P-CL-4W-L-B
123