Endress+Hauser PROline Prosonic Flow 93 Function Manual page 135

PROline Prosonic Flow 93 FOUNDATION Fieldbus
Endress+Hauser
"TRANSDUCER_DISP" (E+H parameters) / base index 1500
Parameter Write access
with operating
mode
(MODE_BLK)
Main Line AUTO - OOS
Multiplex -
Format
3 Transducer Blocks (transmission blocks)
Description
Use this parameter to define the maximum number of places after
the decimal point for the second value displayed in the main line.
Options:
XXXXX. – XXXX.X – XXX.XX – XX.XXX – X.XXXX
Factory setting:
X.XXXX


Note!
• Note that this setting only affects the reading as it appears on the
display, it has no influence on the accuracy of the system's
calculations.
• The places after the decimal point as computed by the measuring
device cannot always be displayed, depending on this setting
and the engineering unit. In these instances an arrow appears on
the display between the measured value and the engineering unit,
(e.g. 1.2 → dm³/s), indicating that the measuring system is
computing with more decimal places than can be shown on the
display.
135