Configuring Call Waiting - AudioCodes Mediant 800B User Manual

Gateway & e-sbc

Hide thumbs Also See for Mediant 800B:

Table of Contents

User's Manual

Table 27-5: Caller ID Permissions Table Parameter Descriptions

[EnableCallerId_Index]

[EnableCallerId_Module]

[EnableCallerId_Port]

[EnableCallerId_PortType]

[EnableCallerId_IsEnabled]

Configuring Call Waiting

The Call Waiting table lets you enable call waiting per FXS port. When call waiting is

enabled for a port and the device receives a call for the port, if the port is busy (i.e.,

currently in another call):

The device responds to the caller with a SIP 182 response (instead of a 486 busy).

The device plays a call waiting indication signal to the busy port.

When the device detects a hook-flash from the port, the device switches to the waiting

The device plays a call waiting ringback tone to the calling party after a 182 response

is received.

For ports that are not configured in the table, call waiting is according to the global

parameter, as described in 'Enabling Call Waiting' on page 556.

In the installed CPT file, you must include the "Call Waiting Ringback" (#17) tone

(heard by the calling party) and "Call Waiting" (#9) tone (heard by the called party,

for FXS interfaces only). For more information, see 'Call Progress Tones File' on

For call waiting support, you must enable call hold for the calling and called

parties, as described in 'Enabling Call Waiting' on page 556.

For additional call waiting configuration, see 'Enabling Call Waiting' on page 556.

The section is applicable only to FXS interfaces.

The following procedure describes how to configure call waiting per port through the Web

interface. You can also configure it through ini file (CallWaitingPerPort) or CLI (configure

voip > gateway analog call-waiting).

Defines an index number for the new table row.

Note: Each row must be configured with a unique index.

(Read-only) Displays the module number on which the port is located.

(Read-only) Displays the port number.

(Read-only) Displays the port type (e.g., FXS).

Enables Caller ID generation (FXS) or detection (FXO) per port.

Mediant 800B Gateway & E-SBC

27. Analog Gateway