Configuring Call Waiting - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
General
Index
[EnableCallerId_Index]
Module
[EnableCallerId_Module]
Port
[EnableCallerId_Port]
Port Type
[EnableCallerId_PortType]
Caller ID
Caller ID
caller-id
[EnableCallerId_IsEnabled]
28.9

Configuring Call Waiting

The Call Waiting table lets you enable call waiting per FXS port. When call waiting is
enabled for a port and the device receives a call for the port, if the port is busy (i.e.,
currently in another call):
1. The device responds to the caller with a SIP 182 response (instead of a 486 busy).
2. The device plays a call waiting indication signal to the busy port.
3. When the device detects a hook-flash from the port, the device switches to the waiting
call.
4. The device plays a call waiting ringback tone to the calling party after a 182 response
is received.
Note:
•
For ports that are not configured in the table, call waiting is according to the global
parameter, as described in ''Enabling Call Waiting'' on page 585.
•
In the installed CPT file, you must include the "Call Waiting Ringback" (#17) tone
(heard by the calling party) and "Call Waiting" (#9) tone (heard by the called party,
for FXS interfaces only). For more information, see ''Call Progress Tones File'' on
page 789.
•
For call waiting support, you must enable call hold for the calling and called
parties, as described in ''Enabling Call Waiting'' on page 585.
•
For additional call waiting configuration, see ''Enabling Call Waiting'' on page 585.
•
The section is applicable only to FXS interfaces.
The following procedure describes how to configure call waiting per port through the Web
interface. You can also configure it through ini file (CallWaitingPerPort) or CLI (configure
voip > gateway analog call-waiting).
Version 7.2
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
(Read-only) Displays the module number on which the port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (e.g., FXS).
Enables Caller ID generation (FXS) or detection (FXO) per port.

[0] Disable

[1] Enable
627
Description
Mediant 1000B Gateway & E-SBC
28. Analog Gateway