Figure 3-7 Installing The Mounting Feet Bracket On Size 1 Drives; Figure 3-8 Overall Size 2A / 2B Dimensions - Emerson MP25A4 User Manual

Safety Product Mechanical
Information information Installation

Figure 3-7 Installing the mounting feet bracket on size 1 drives

1
MA1
MA2

Figure 3-8 Overall size 2A / 2B dimensions

495mm (19.49in)
453mm (17.84in)
93mm
(3.66in)
NOTE
With the SMARTCARD installed to the drive, the depth measurement increases by 7.6mm (0.30 in).
Mentor MP User Guide
Issue: 3
Electrical Getting Basic
installation started parameters
2
1
301mm (11.85in)
640mm
(25.20in)
302mm
(11.89in)
www.controltechniques.com
Running the SMARTCARD
Optimization
motor operation
The bottom mounting bracket (1) should be installed to the back plate first
with the screws fully tightened. The drive should then be lowered onto the
bracket and slotted in. The top mounting bracket (2) should then be slotted
into the drive and the top holes marked for mounting (380mm [14.96 in]
from the centre of the holes on the bottom mounting bracket). Once the
holes have been drilled, fix the top mounting bracket accordingly and
tighten the screws.
It is not necessary to tighten the bottom mounting brackets with the drive in
place. The brackets are designed to clamp the drive heatsink against the
back plate.
85mm
(3.35in)
68mm
(2.68in)
126mm
(4.96in)
Onboard Advanced Technical
PLC parameters data
472mm (18.58)
11.5mm (0.45in)
495mm (19.49in)
UL
Diagnostics
information
8 holes to
suit M8
80mm
(3.15in)
80mm
(3.15in)
65mm
(2.56in)
19