Gear Shift Position Sensor Check (Gps) - Husqvarna TC 450 Workshop Manual

Hide thumbs Also See for TC 450:

Table of Contents

Gear shift position sensor checking (GPS: Gear Position Sensor)

Set the tester on "Ohm" position then detach the 6 ways connector (1) from the

main wiring harness (the gear shift position sensor is fastened on the alterna-

tor cable with a clamp). Ground a tester terminal on the engine then insert the

other one in the hole where is the gear sensor BLACK cable (2). The lever (3) is

placed on the left-hand side of the engine. After every shift, the lever automati-

cally returns to horizontal position. First gear is engaged by pushing the lever

downwards; all the other gears are engaged, by pushing the lever upwards. See

the table below for the data to be checked.

NEUTRAL (open circuit)

Part. N. 8000 H1344 (10-2009)

ELECTRIC SYSTEM, DIGITAL INSTRUMENT

Show Quick Links

Chapters

Table of Contents