RPS LED
The RPS LED shows the operating status of a connected redundant power
unit. Indicator states include:
•
Off — The redundant power supply is not connected.
•
Green — The redundant power supply is operating normally.
•
Red — The redundant power supply has failed.
Console Port
The console interface can be accessed from the RS-232 serial port or a
Telnet connection. The console port uses a standard null-modem cable. For
instructions on configuring your switch using the console, see
Interface."
Port LEDs
Each port has a dedicated LED whose mode may be switched using the button
located on the front panel. The LED mode button will toggle through the
following modes:
•
Link/Act Mode
•
Speed Mode
•
Duplex/Collision Mode.
1 0 / 1 0 0 P o r t s
Link/Act Mode
Speed Mode
Duplex/Collision
Mode
Off
No 10/100-Mbps link is established.
Steady green
A link is established on the port.
Blinking green
There is data transmission on the port.
Off
A 10-Mbps link is established or no link.
Steady green
A 100-Mbps link is established on the port.
Off
Port is operating on Half-Duplex mode or no
link.
Steady green
Port is operating on Full-Duplex mode.
Blinking green
Port is operating on Half-Duplex and a collision
occurs.
"Console
23
Introduction