Safety Rules; General; Orderly Measures; Power Supply - Omicron Lab CT Analyzer User Manual

Safety Rules

Before operating the CT SB2 switch box, read the instructions in this section
carefully. If you do not understand some safety rules, contact OMICRON
electronics GmbH before proceeding. The CT SB2 is designated for use with the
CT Analyzer. Therefore, observe the safety rules both in this User Manual and
in the CT Analyzer User Manual when working with the CT SB2 switch box.
Maintenance and repair is only permitted by qualified experts either at the
factory or certified external repair centers.

General

Always observe the five safety rules:
• Disconnect completely
• Secure from reconnection
• Verify that the installation is dead
• Carry out grounding and short-circuiting
• Provide protection against adjacent live parts

Orderly Measures

The CT SB2 User Manual or the e-book version of the manual always has to be
available on the site where the CT SB2 is being used. All users of the CT SB2
must read and observe the safety rules and all relevant instructions for
installation and operation.
The CT SB2 may be used only as described in this User Manual. Any other use
is not in accordance with the regulations. The manufacturer and the distributor
are not liable for damage resulting from improper usage. The user alone
assumes all responsibility and risk.
Full compliance with the regulations also includes following the instructions
provided in this User Manual.

Power Supply

Supply the CT SB2 only from a power outlet that is equipped with protective
ground (PE). Instead of supplying the CT SB2 from phase-neutral, it may also
be supplied from phase-phase. However, the voltage must not exceed
240V AC.
Safety Rules
7