Five Safety Rules; General; Operation - Omicron Lab SPECTANO 100 User Manual

Hide thumbs Also See for SPECTANO 100:
Table of Contents

Advertisement

SPECTANO 100 User Manual
2.2

Five safety rules

2.3

General

2.4
2.4
Opera

Operation

Operation
6
DANGER
Death or severe injury caused by high voltage or current
Always observe the safety rules specified in 2 "Safety instructions" in this
User Manual.
Before connecting any test leads to a test object, always observe the five safety
rules for working with high power:
Disconnect completely.
Secure against re-connection.
Verify that the installation is dead.
Carry out grounding and short-circuiting.
Provide protection against adjacent live parts.
Do not touch any terminals without a visible connection to ground.
y terminals without a visible con
Before handling SPECTANO 100 in any way, connect its equipotential
ling SPECTANO 100
PECTANO 100 in any way
ground (see Figure 6-2 "SPECTANO 100 rear view" on page 18) with a solid
ee Figure 6-2 "SPECTANO 100
ee Figure 6-2 "SPEC
connection of at least 6 mm
tion of at least 6 mm
of at least 6 m
laboratory.
oratory.
Do not open the
Do not open the SPECTANO 100 housing. Opening the device invalidates
pen
SPEC
SPECTANO 10
all warranty claims!
all warranty claims!
ty claims!
Do not repair, modify, extend, or adapt SPECTANO 100 or any accessories.
Do not repair, modify, exte
Do not repair, modif
Use only the delivered cables and the delivered grounded power supply.
Use only the delivered
se only the d
Use SPECTANO 100 and its accessories only in a technically sound
Use
Use SPECTANO 1
SP
condition and when its use is in accordance with the local safety regulations.
condition and wh
condition
In particular,
In particular, avoid disruptions that could in turn affect safety.
In p
Before operating SPECTANO 100, ground it as described in 2.3 "General"
on page 6.
Ensure that the ground is in good condition, clean, and free of oxidation.
Before handling SPECTANO 100 in any way, ground any parts of the test
object which have to be connected to ground.
Always turn off SPECTANO 100 with the power switch before connecting or
disconnecting any cables.
Never remove any cables from SPECTANO 100 or the test object during a
test.
rcuiting. g
djacent live parts.
live parts.
inals without a visible con
in a
0 0
TA
2 2
2
cro
cross-sec
cross-section to a ground connection in the
ys observe the five safety
the five safet

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dts1

Table of Contents