Setting Up And Connecting The Ct Analyzer; Preparing And Configuring The Test - Omicron Lab CT Analyzer User Manual

CT Analyzer User Manual
7.2

Setting Up and Connecting the CT Analyzer

7.3

Preparing and Configuring the Test

I/0
132
It is possible to configure the guesser function of the CT Analyzer in a way that
it checks whether the user has entered all necessary values and data relevant
for an automatic assessment prior to the test start. The respective parameters
are then marked by a star ("*") in the CT-Object card. If the user did not enter
data for one or more of these parameters, no automatic assessment is
performed and the CT Analyzer displays an "Assessment not available"
message after the test is finished.
This option can be used to avoid an automatic assessment if important
parameters were guessed by the CT Analyzer and not entered by the user. This
behavior can be selected using the "Check "*" settings before start" option in the
default test settings (see section 5.7.3 "Miscellaneous Settings" on page 70).
This settings page also provides an option to enable the display of a
corresponding message prior to the test start.
1. Set up the CT Analyzer as described in section 2.2 on page 22.
2. Connect the CT to the CT Analyzer as described in chapter 2.
– Refer to section 2.4.1 on page 24 for detailed information on how to
connect the CT Analyzer for the CT test.
– Be sure that the polarity of all wires is correct.
1. Proceed as follows to display the CT-Object card with a new CT test.
If the CT Analyzer is already switched on:
– If necessary, display the CT-Object card and then press the Main soft key
to display the main menu.
– In the main menu, select "New CT Test" and press the OK soft key to
initialize a new CT test.
– The display shows the CT-Object card, ready to start a test.
If the CT Analyzer is switched off:
– Switch the CT Analyzer on.
– After the boot process is finished, the green LED is on and the red LED is
off.
– The display shows the CT-Object card, ready to start a test.