Safety Rules; General Rules For Safe Operation - Omicron Lab CT Analyzer User Manual

Safety Rules

Before operating the CT Analyzer, read the instructions in this section carefully.
If you do not understand some safety rules, contact OMICRON before
proceeding. When working with the CT Analyzer, observe the following safety
rules.
Maintenance and repair is only permitted by qualified experts at OMICRON
repair centers.

General Rules for Safe Operation

• Always observe the five safety rules:
– Disconnect completely
– Secure from reconnection
– Verify that the installation is dead
– Carry out grounding and short-circuiting
– Provide protection against adjacent live parts
• Do not touch any terminals without a visible connection to ground.
• Always be aware of the danger of the high voltages and currents associated
with this equipment. Pay attention to the information provided in this user
manual.
• Use the CT Analyzer and its accessories only in a technically sound
condition and when its use is in accordance with the safety regulations for the
specific job site and application.
• Use only original accessories available from OMICRON.
• If the CT Analyzer or any add-on device or accessory seems to be
functioning improperly, please call the OMICRON Hotline (refer to
chapter "OMICRON Service Centers" on page 185).
• Do not operate the CT Analyzer when explosive gas or vapors are present.
• Do not operate the CT Analyzer under wet or moist conditions
(condensation).
• Do not open the CT Analyzer. Opening the CT Analyzer invalidates all
warranty claims. Do not repair, modify, extend, or adapt the CT Analyzer or
any accessories.
• Do not insert objects (e.g. screwdrivers, etc.) into the ventilation slots or any
input/output sockets.
Safety Rules
9