Performing Measurements With Quick Test; Advanced Measurement - Omicron Lab CT Analyzer User Manual

8.3

Performing Measurements with Quick Test

Measurements using Quick Test are not automatically stopped by the
How to get there:
CT Analyzer. Such measurements have to be stopped manually by the
Press the Main soft key in
user.
any test card
Main Menu:
Proceed as follows to perform measurements using the Quick Test feature:
- New Quick-Test
OK soft key
1. Select New Quick-Test from the main menu and press the OK soft key to
-> CT-Quick card
Figure 8-2
2. Select the measurement type and connect your test object to the
3. Define your measurement quantities.
4. Start and stop your measurement by pressing the
5. After starting a measurement, the Results card is displayed automatically,
8.4

Advanced Measurement

The Advanced measurement type offers complete multimeter measurement
How to get there:
functionality and free adjustment of all measurement quantities, such as AC or
Press the Main soft key in
DC signal output, voltage or current output, output frequency, measurement
any test card
mode (DC, RMS or frequency-selective) for the input, etc.
Main Menu:
- New Quick-Test
Using the Advanced measurement type it is also possible to use input "Sec" of
OK soft key
the CT Analyzer as a voltmeter for measuring external voltages up to
CT-Quick card:
Measurement Type:
150V
Advanced
Caution: When using Quick Test, input "Sec" of the CT Analyzer is able to
measure voltages up to 150V
even mains voltages to the CT Analyzer inputs! This will damage the
CT Analyzer!
open Quick Test. The display then shows the CT-Quick card.
CT-Quick card
CT Analyzer correspondingly (see sections 8.4 to 8.10 below).
showing the measurement results.
with frequencies up to 4kHz.
RMS
Using the Quick Test Feature
. Do not connect voltages above 150V or
RMS
key.
I/0
139