Basic Measurement Setup For Single-Ratio Ct Testing - Omicron Lab CT Analyzer User Manual

CT SB2 User Manual
3.4 Basic Measurement Setup for Single-Ratio CT
Testing
22
Note: If you do not want to perform burden or primary winding resistance
measurement, you should preferably use the normal single-ratio CT test mode
of the CT Analyzer without using the CT SB2. Remove the data connection
cable from the remote control interface of the CT Analyzer if you do not use the
CT SB2 for CT testing with the CT Analyzer.
CT
*
*
For information how to connect the communication link between the CT SB2 and the
CT Analyzer, please refer to section 3.2 on page 20.
Figure 3-3 Basic measurement setup for single-ratio CT testing (no burden
measurement, no primary winding resistance measurement)
Burden
Wiring for burden
measurement see
Figure 3-4
*