Units Of Values; Tps1100 Instrument Modes Of Operation - Leica tps1100 Reference Manual

GeoCOM Reference Manual
3.4

UNITS OF VALUES

All parameters are based on the SI unit definition, if not explicitly indicated
differently. The SI units, and their derivatives, used are:
Abbreviation
M
Rad
Sec
Hpa
C
3.5

TPS1100 INSTRUMENT MODES OF OPERATION

In respect to communication, the TPS1100 instrument knows several states in
which it reacts differently. The main state for GeoCOM is online state or mode.
There it is possible to use all RPC's, which are described in this manual.
Especially we will describe the possibilities of changing the state by the built-in
RPC's. For the ASCII protocol refer to section 3.1.3 - Modes of Operation
Concerning Communication.
The possible states can be described as follows:
Off The instrument is switched off and can be switched on and put into
online mode by using
Local The instrument is in local mode. GeoCOM is not active hence, RPC's
cannot be used. To switch into online mode start the "Configuration"
menu on the instrument, open the submenu "Communication mode"
and select "GeoCOM On-Line mode" (in default configuration).
Online Also called Remote mode. The instrument accepts RPC's.
COM_Local
COM_SwitchOffTPS
sleep mode.
RCS The instrument accepts Remote Control sequences. This is not subject
of this manual and will be described elsewhere.
GSI/Meas In this mode the user can measure coordinates and save the values
onto the PC-Card. GSI commands will be accepted in this mode.
Since this is not subject of this manual this mode will not described
here in more detail.
TPS1100 - Version 1.05
Unit
( Meters )
( Radians )
( Seconds )
( Hekto Pascal )
(Celsius )
Table 3-2: SI Units
COM_SwitchOnTPS
can be used to switch into local mode.
will switch off the instrument or put it into
Fundamentals of Programming GeoCOM
Description
for lengths, co-ordinates, ...
for angles
for time
for pressure
for temperature
.
3-13