Leica tps1100 Reference Manual page 78

GeoCOM Reference Manual
AUT_RC_INCACC
RC_FATAL
RC_ABORT
RC_COM_TIMEDOUT
Additionally with position mode
AUT_RC_NO_TARGET
AUT_RC_MULTIPLE_TARGETS
AUT_RC_BAD_ENVIRONMENT
AUT_RC_ACCURACY
AUT_RC_DEV_ERROR
AUT_RC_NOT_ENABLED
See Also
AUS_GetUserAtrState, AUS_SetUserAtrState
AUS_GetUserLockState, AUS_SetUserLockState
AUT_ReadTol
AUT_ReadTimeout, AUT_SetTimeout
COM_GetTimeOut, COM_SetTimeOut
TMC_GetFace
Example
The example program performs a change face. If a measurement error
occurs, the automatic inclination correction is switched off and the change
face starts again.
RC_TYPE
BOOL
AUT_POSMODE
rc=RC_IVRESULT;
TPS1100 - Version 1.05
,
AUT_SetTol
rc, rch;
TryAgain = TRUE;
POSMode = AUT_PRECISE;
In the position mode
valid measurement of target's inclination
was not possible. The positioning is
inexact.
Fatal error.
Function aborted.
Communication timeout. (perhaps
increase COM timeout, see
COM_SetTimeout
.
AUT_TARGET
No target found
Multiple targets found.
Inadequate environment conditions.
Inexact fine position, repeat
positioning
During the determination of the
angle deviation error detected, repeat
change face
ATR mode not enabled, enable ATR
mode
Automation - AUT
AUT_PRECISE
)
a
7-21