Leica tps1100 Reference Manual page 173

GeoCOM Reference Manual
TMC_NO_FULL_CORRECTION
TMC_ACCURACY_GUARANTEE
TMC_ANGLE_ERROR
TMC_BUSY
RC_ABORT
RC_SHUT_DOWN
RC_IVPARAM
See Also
TMC_IfDataAzeCorrError
TMC_IfDataIncCorrError
Example
RC_TYPE
TMC_COORDINATE
rc = VB_TMC_SetHandDist(10, 1, TMC_AUTO_INC)
if (rc == RC_OK)
{
// calculate coordinates
TPS1100 - Version 1.05
Theodolite Measurement and Calculation - TMC
The results are not corrected by all active
sensors.
In order to secure witch correction is
missing use the both functions
TMC_IfDataAzeCorrError
TMC_IfDataIncCorrError
This message is to be considers as
warning.
Accuracy is not guaranteed, because the
result consisting of measuring data which
accuracy could not be verified by the
system.
You can a forced incline measurement
perform or switch off the incline.
This message is to be considers as info.
Problems with angle res. incline sensor. A
valid angle could not be measured.
At repeated occur call service.
TMC resource is locked respectively
TMC task is busy.
Repeat measurement.
Measurement through customer aborted.
System power off through customer.
Invalid parameter
rc;
Coordinate
and
16-25