Leica tps1100 Reference Manual page 201

GeoCOM Reference Manual
Example
see example TMC_IfDataAzeCorrError
16.7.9 TMC_SetAngSwitch - Enable/disable angle corrections
TMC_ SetAng Switch........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................... 2016
2016 ................................................................................................................................................................................................................................................................TMC_ SetAng Switch
C-Declaration
TMC_SetAngSwitch(TMC_ANG_SWITCH Switch)
VB-Declaration
VB_TMC_SetAngSwitch(ByVal Switch As TMC_ANG_SWITCH)
ASCII-Request
%R1Q,2016:
ASCII-Response
%R1P,0,0:RC
Remarks
With this function you can enable/disable follow angle measurement correction.
incline:
stand axis:
collimation:
tilt axis:
Note: You can set the various corrections only, if no distance is existing! (Use the
function
TMC_DoMeasure(TMC_CLEAR,..)
Parameters
Switch
Return-Code
RC_OK
TMC_BUSY
TPS1100 - Version 1.05
Theodolite Measurement and Calculation - TMC
The incline will be considered in the angle
measurement if enabled.
The stand axis will be considered in the angle
measurement if enabled.
The collimation will be considered in the angle
measurement if enabled
The tilt axis will be considered in the angle
measurement if enabled.
Angle measurement corrections
Corrections are set
TMC resource is locked respectively TMC task is
busy or a distance is existing.
Clear distance and try it again.
in order to clear the distance)
16-53