Leica tps1100 Reference Manual page 76

GeoCOM Reference Manual
}
break;
}
}
rc = AUS_SetUserAtrState(OFF); // Note: LOCK mode will
hrc = COM_SetTimeOut(nOldComTimeOut);// Set old time-
7.3.6 AUT_ChangeFace - Turns telescope to other face
AUT_ChangeFace............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................... 9028
9028 ................................................................................................................................................................................................................................................................AUT_ChangeFace
C-Declaration
AUT_ChangeFace(AUT_POSMODE PosMode,
VB-Declaration
VB_AUT_ChangeFace4(PosMode As Long,
ASCII-Request
%R1Q,9028:PosMode,ATRMode,0
ASCII-Response
%R1P,0,0:RC
Remarks
This procedure turns the telescope to the other face.
Is in the moment of the function calling an other control function active it
will be terminated before.
The start angle is automatically measured before the position starts.
If the position mode is set to normal (
allowed that the current value of the compensator measurement is inexact.
Positioning precise (
compensator measurement. If this measurement is not possible, the position
does not take place.
If ATR is possible and activated and the ATR mode is set
AUT_TARGET
area. In addition, the target is locked after positioning if the
is set.
TPS1100 - Version 1.05
AUT_ATRMODE ATRMode,
BOOLE bDummy)
ATRMode As Long,
bDummy As Boolean)
PosMode = AUT_PRECISE
the instrument tries to position onto a target in the destination
// be automatically
// reseted !
// out
PosMode = AUT_NORMAL
) forces a new
Automation - AUT
) it is
to
status
LockIn
7-19