Leica tps1100 Reference Manual page 80

GeoCOM Reference Manual
ASCII-Request
%R1Q,9037: dSrchHz[double], dSrchV[double],0
ASCII-Response
%R1P,0,0:RC
Remarks
This procedure performs a positioning of the Theodolite axis onto a
destination target. If the target is not within the sensor measure region a
target search will be executed. The target search range is limited by the
parameter
direction. If no target found the instrument turns back to the initial start
position. The ATR mode must be enabled for this functionality, see
AUS_SetUserAtrState
Any actual target lock is terminated by this procedure call. After position,
the target is not locked again.
The timeout of this operation is set to 5s, regardless of the general position
timeout settings. The positioning tolerance is depends on the previously set
up the fine adjust mode (see
AUT_GetFineAdjustMode
Tolerance settings (with
influence to this operation. The tolerance settings as well as the ATR
measure precision depends on the instrument's class and the used EDM
measure mode (The EDM measure modes are handled by the subsystem
TMC).
Parameters
DSrchHz
DSrchV
bDummy
Return-Codes
RC_OK
AUT_RC_TIMEOUT
TPS1100 - Version 1.05
in V- direction and by parameter
dSrchV
and
AUT_SetTol
In
In
In
dSrchV As Double,
bDummy As Boolean)
AUS_GetUserAtrState
AUT_SetFineAdjustMoed
).
and
AUT_ReadTol
Search range Hz-
Search range V-axis
It's reserved for future use, set
always to FALSE
Execution successful.
Timeout while positioning of one or both
axes. The position fault lies above
100[cc]. (perhaps increase AUT timeout,
see
AUT_SetTimeout
Automation - AUT
in Hz -
dSrchHz
.
and
) have no
bDummy
)
7-23