Leica tps1100 Reference Manual page 31

GeoCOM Reference Manual
Return Code
RC_COM_CANT_ENCODE_
REP
RC_COM_SYSTEM_ERR
RC_COM_FAILED
RC_COM_NO_BINARY
RC_COM_INTR
RC_COM_REQUIRES_
8DBITS
RC_COM_TR_ID_
MISMATCH
RC_COM_NOT_GEOCOM
RC_COM_UNKNOWN_PORT
TPS1100 - Version 1.05
Fundamentals of Programming GeoCOM
Val Description
3082 Can't encode reply in server. The server has
attempted to encode the reply but has failed.
This can be caused by the calling procedure
trying to pass too much data back to the client
and in so doing has exceeded the maximum
packet length.
3083 Communication hardware error
3085 Mess into communication itself. Should be
OK once the node has been recycled, i.e.
powered-down and -up again.
3086 Unknown protocol. An unknown (or not yet
supported) Transport or Network protocol has
been used. Could appear when using differing
GeoCOM versions on client and server.
3087 Call interrupted. Something has happened
outside of the scope of GeoCOM, which has
forced the current RPC to abort itself.
3090 This error indicates desired protocol requires
8 data bits
3093 Request and reply transaction ids do not
match. Somewhere along the line a packet
(usually a reply) has been lost or delayed.
GeoCOM tries to bring everything back to
order but if this error continues during the
session it may be wise to inspect the line and,
at least, to restart the session. The
immediately following RPC may be lost.
3094 Parse failed; data package not recognised as
GeoCOM communication package
3095 Tried to access an unknown hardware port.
The application has not taken the physical
resources of the machine on which it is
running into account.
3-18