Table of Contents
Advertisement
GeoCOM Reference Manual
determine the axis in horizontal and vertical direction. If the search was
successful, the telescope will position to the target in a exactness of the
field of vision (±1.25[GON]), otherwise the instrument turns back to the
initial start position. With the ESC key a running search process will be
aborted. The ATR mode must be enabled for this functionality, see
AUS_SetUserAtrState()
positioning use fine adjust (see
Note: If you expand the search range of the function
have a target search and a fine positioning in one function.
Parameters
Hz_Area
V_Area
bDummy
Return-Codes
RC_OK
RC_IVPARAM
AUT_RC_MOTOR_ERROR
RC_FATAL
RC_ABORT
AUT_RC_NO_TARGET
AUT_RC_BAD_ENVIRONMENT
AUT_RC_NOT_ENABLED
AUT_RC_DETECTOR_ERROR
RC_COM_TIMEDOUT
See Also
AUS_SetUserAtrState
AUS_GetUserAtrState
AUT_FineAdjust
TPS1100 - Version 1.05
and
AUS_GetUserAtrState
AUT_FineAdjust
In
Horizontal search region [
In
Vertical search region [
In
It's reserved for future use, set
always to
Execution successful.
Invalid parameter.
Instrument has no 'motorization'.
Fatal error.
Function aborted.
No target found.
Inadequate environment conditions.
ATR mode not enabled, enable ATR
mode
AZE error, at repeated occur call service
Communication timeout. (perhaps
increase COM timeout, see
COM_SetTimeout
Automation - AUT
. For a exact
) afterwards.
AUT_FineAdjust
rad
rad
FALSE
)
, then you
].
].
bDummy
7-26
Hide quick links:
Advertisement
Table of Contents
