Leica tps1100 Reference Manual page 69

GeoCOM Reference Manual
7.3.2 AUT_SetTol - Set the positioning tolerances
AUT_SetTo l........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 9007
9007 ................................................................................................................................................................................................................................................................AUT_SetTo l
C-Declaration
AUT_SetTol(AUT_POSTOL
VB-Declaration
VB_AUT_SetTol(TolPar As AUT_POSTOL)
ASCII-Request
%R1Q,9007:ToleranceHz[double], Tolerance V[double]
ASCII-Response
%R1P,0,0:RC
Remarks
This command stops every movement and sets new values for the
positioning tolerances of the Hz- and V- instrument axes. This command is
valid for TCM and TCA instruments only.
The tolerances must be in the range of 1[cc] ( =1.57079 E-06[
100[cc] ( =1.57079 E-04[
Note: The max. Resolution of the angle measurement system depends on the
instrument accuracy class. If smaller positioning tolerances are required,
the positioning time can increase drastically.
Parameters
TolPar
Return-Codes
RC_OK
RC_IVPARAM
MOT_RC_UNREADY
See Also
AUT_ReadTol
Example
see
AUT_ReadTol
TPS1100 - Version 1.05
TolPar)
] ).
rad
in
The values for the positioning tolerances
in Hz and V direction [
Execution successful.
One or both tolerance values not within the
boundaries (1.57079E-06[
to 1.57079E-04[
rad
Instrument has no motorization
Automation - AUT
rad
] =1[cc]
rad
] =100[cc]).
] ) to
rad
].
7-12