The function sets the parent window-handle that GeoCOM uses when it
creates a dialog or message box. If this function is not called, GeoCOM
will use the
Note:
HWND
defined. When MFC libraries are used,
defined. Otherwise the user must
unresolved externals.
Parameters
handle
Return Codes
RC_OK
See Also
-
Example
RC_TYE
HWND
rc = COM_UseWindow(hWnd);
5.3.12 COM_SetConnDlgFlag - Set Connection Dialog Flag
COM_ SetConnDlg Flag ...................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................... -
C-Declaration
COM_SetConnDlgFlag( BOOLE bShow )
VB-Declaration
VB_COM_SetConnDlgFlag( ByVal bShow As Long )
ASCII-Request
-
ASCII-Response
-
Remarks
This function sets or clears the connection dialog flag. If cleared, then the
user will not be asked by a dialog box if all possible settings should be tried