Leica tps1100 Reference Manual page 86

GeoCOM Reference Manual
See Also
AUT_SetFineAdjustMode
Example
see AUT_SetFineAdjustMode
7.3.10 AUT_SetFineAdjustMode - Set the fine adjustment mode
AUT_SetFineAdjustM ode.................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................. 9031
9031 ................................................................................................................................................................................................................................................................AUT_SetFineAdjustM ode
C-Declaration
AUT_SetFineAdjustMode(AUT_ADJMODE AdjMode)
VB-Declaration
VB_AUT_SetFineAdjustMode(AdjMode As Long)
ASCII-Request
%R1Q,9031:AdjMode[long]
ASCII-Response
%R1P,0,0:RC
Remarks
This function sets the positioning tolerances (default values for both
modes) relating the angle accuracy or the point accuracy for the fine adjust.
This command is valid for all instruments, but has only effects for TCA
instruments. If a target is very near or held by hand, it's recommended to
set the adjust-mode to AUT_POINT_MODE.
Parameters
AdjMode
Return-Codes
RC_OK
RC_IVPARAM
See Also
AUS_GetUserAtrState
Example
RC_TYPE
AUT_ADJMODE
TPS1100 - Version 1.05
in
AUT_NORM_MODE
angle tolerance
AUT_POINT_MODE
point tolerance
Execution successful
Invalid mode
Result;
AdjMode;
Automation - AUT
: Fine positioning with
: Fine positioning with
7-29