831] Mgi Parameters - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[ 831] MGI PARAMETERS

2 3 3 B
This MMC provides a mean to configure the Internet Protocol(IP) addressing of the MGI
card(s) in the system.
No Parameter
0 IP ADDRESS
1 GATEWAY
2 SUB MASK
3 IP TYPE
4 PUBLIC IP
5 PUB PORT
6 MAC ADDR
8 CARD RESET
9 IP VERSION
10 QOS ENABLE
The OfficeServ 7100 systems
If MPMGI port (the embeded mgi) is selected, IP ADDRESS, GATEWAY, SUB
MASK, CARD RESET parameters can not be set in this MMC because these pa-
rameters and the system values are the same. The system values can be refered
in MMC830
MGI PARAMETERS
- IP ADDRESS, GATEWAY, and SUB MASK—any changes to these parameters
- When changing any IP address/value, three digits must be entered for each
2-342
Specifies the IP address for the MGI card.
Specifies the designated IP gateway address used for contacting
IP devices beyond the local subnet.
Specifies the IP subnet mask. This parameter is used by the system to
calculate the range of IP devices(subnet) that are within 'direct reach'
of the MGI.(without having to go through the designated network IP
gateway)
Specifies if the system will be routing data over a public or private
network.
The MGI will originate communications, to IP phones and VoIP
connections outside the local network, using this IP address. If this
IP address sets 0.0.0.0, 255.255.255.255 or default value then this
MGI card uses private IP only. See System IP Type on MMC 830.
Public Port
Displays the MAC address of an MGI card
This option is only shown in case of installed MGI64/MGI16 card.
Reboots MGI card.
Specifies MGI IP version is IPv4 / IPv6. This option is not shown in
OfficeServ 7200 system.
Specifies use of QOS. This option is only shown in case of installed
MGI card.
will not be applied until the MGI card is reset.
(octet) field. For example, 192.168.1.10 should be entered as 192 168 001 010.
Description
(not supportted MGI16/ 64)
Samsung Business Communications