832] Voip Access Code - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[ 832] VoIP ACCESS CODE

2 3 4 B
Provides a means to apply the Internet Protocol(IP) address to the VoIP gateway. This
MMC also assigns the number of channels that can be used for IP faxes.
TABLE(00~62): Outbound or Inbound table used for specific access codes. Usually when
the MCP2 card is used as a VoIP gateway, the Outbound table is used. The Inbound table is
used to determine the number of digits to receive before processing the call. Each table has
63 entries(00~62).
No Option
0 ACCESS DGT
1 DGT LENGTH
2 DEL.LENGTH
3 INSERT DGT
4 IP TABLE 1
6 IP START
7 SERVER USE
8 SIP SIGNAL
2-344
This is the access code that is used once the VoIP gateway is ac-
cessed; this directs a call based on the routing tables used. An access
code table then references an access code and correlates an IP ad-
dress to the access code for routing. A maximum of eight digits or alpha-
numeric characters are available.
This field requests the number of digits that are expected to be received
to make up the whole access code.
This is the number of digits to delete after receiving the access code.
If no digits are deleted the access code will be sent as part of the call to
the destination to continue routing.
Digit(s) to insert for routing at the destination. This can be used when
different numbering plans exist or if a dial 9 access is to be inserted in
the dialled digits.
This is the first table referenced for routing the access code to an IP
address. The system has 64 IP tables(00~63) with 16 entries(00~15) in
each table. See MMC 833.
This entry indicates where in a table to start looking for an IP code to
associate with the access code. This can be used to manage where to
start looking for an IP address in high traffic VoIP gateway applications.
For example: If IP address routing to the desired destination is known to
be in the last seven entries of a table, the IP START location would be 8.
IP address searching would start at entry 8.
When using H.323 trunking, this option specifies the use of GateKeeper
for the corresponding access (This option is applied only when GK
ROUTING is enabled in program 836.)
It is also used when using SIP trunking. When using SIP trunking via
SIP proxy/SIP server (as with the case of a SIP provider), this option
should be set to YES to enable. When enabled, SIP trunking will follow
settings in MMC 837 and MMC 832/833 will not be used. If using SIP
trunking to another SIP gateway (SIP peering), then this option should
be set to NO to disable it. If disabled, then mmc 832/833 will be
applied and mmc 837 will not be applied.
This indicates the transport type in SIP message signalling. SIP
message can be transported either using UDP or TCP.
Description
Samsung Business Communications