416] Assign E & M/Did Ringdown - Samsung OfficeServ 7000 Series Programming Manual

[ 416] ASSIGN E & M/DID RINGDOWN
1 1 3 B
This MMC defines which ring destination table an E & M or DID trunk will follow
for incoming calls. There are three options for each trunk as defined below.
No
0 FOLLOW INCOM DGT
1 FOLLOW DID TRANS
2 FOLLOW TRK RING
C ONDITIONS
5 5 4 B
R2MFC trunk lines only support the 'FOLLOW INCOM DGT' and 'FOLLOW DID
TRANS' options.
MMC [413]
This MMC is not shown in OfficeServ 7100
OfficeServ 7030
D EFAULT DATA
5 5 5 B
FOLLOW INCOMING DIGIT
A CTION
5 5 6 B
1) Press Transfer button and enter 416.
Display shows:
2) Enter desired trunk number.(e.g., 705)
OR
Press Volume button to make selection and
press Right Soft button to move cursor.
OR
Select all trunks.
Samsung Business Communications
Option
When a trunk is set to this option, calls will ring at the
destination that matches the digits received from the Trunk line.
When a trunk is set to this option, calls will ring at the
destination defined in MMC 714 that matches the digits
received from the TRUNK LINE.
If this option is selected, press the Right Soft button and 'NO.
RCV DIGIT' will appear on the display. Here is where the
number of incoming digits from Trunk Line must be entered
(0-4). When a trunk is set to this option, calls will ring at the
destination defined in MMC 406 for that trunk. If the destination
defined in MMC 406 is a VMAA port or group then the system
will repeat the digits received from the CO to the port when it
answers.
does not support E1 trunk card.
CHAPTER 2. MMC Programming
Description
/ OfficeServ 7030. OfficeServ 7100
DISPLAY
[ 7 0 1] EM/DD RING
U U
FOLLOW INCOM DGT
[705] EM/DD RING
F O LLOW INCOM DGT
U U
[ALL] EM/DD RING
F O LLOW INCOM DGT
U U
/
2-127