Samsung OfficeServ 7000 Series Programming Manual page 405

21 IMS OPTION
22 ASSERTED ID
23 PRIVACY
24 SIP PEERING
25 CLIP TABLE
26 SS TYPE
27 302 RESP
USER TABLE
28 DEST TYPE
Samsung Business Communications
messages not from the specified SIP server.
When enabledt, SIP headers that are commonly used in
IMS environment will automatically be applied.
If ASSERTED ID is enabled, outbound message's FROM
header will contain individual station number and IP-
Asserted-ID header will contain primary number which is
assigned by the SIP server.
When set, FROM header in outbound SIP message will
have user name of 'Anonymous' which hides caller infor-
mation. In this case, representative number instead will
be put into P-Asserted-ID header.
In general cases when making the call by interworking
with the SIP server, the SIP Server IP is used in the
From/To Header, however this is the option used when to
use its own IP of the terminal in case of a specific SIP
server.
Refers to SEND CLI NUMBER(MMC 323), which pro-
vides calling party identification when using the MGI as a
SIP gateway.
This provides station ID of the calling station. A single-
digit value corresponding to the desired table in MMC
323 should be entered here. This is only used when
MMC 405 value is null.
Indicates how SIP call flow will be done; Samsung vs.
Standard. When set to Samsung, system will not follow
standard SIP call flow that is recommended in RFCs, but
instead will initiate Samsung proprietary call flow. Default
value is Standard. This value should remain at default
except for special cases..
This option is used for configuring external call forward
method. During external call forward condition, if this
option is set to Enable, system responds back to the SIP
carrier with a 302 message which will allow the SIP car-
rier to handle the call forward. If this option is disabled,
then the OfficeServ system will initiate a second invite
message to the final forward destination. When Office-
Serv handles the forwarding to the final destination, then
more MGI resources will be used. If the SIP provider
supports the 302 method, this option should be enabled.
This MMC is not shown in OfficeServ 7100/ OfficeServ
7030.
This option selects the field that will be used to specify
the final recipient destination. The field can be either
CHAPTER 2. MMC Programming
Disable
Disable
Disable
DISABLE
1
Standard
Disable
1
To-Header
2-363