Samsung OfficeServ 7000 Series Programming Manual page 178

CHAPTER 2. MMC Programming
No Option
6 CLIR w NUMB
7 SAME CONNID
8 CD PLAN
9 CD TYPE
10 TIME SYNC
C ONDITIONS
5 7 0 B
Before setting the PRI program, the J2 jumper of the TEPRI or TEPRI2 card must be
set to 'ON' for PRI mode.
After changing this program, run MMC 418, BRI AND PRI CARD RESTART, to
apply the new setting.
MMC [420]
This MMC is not shown in OfficeServ 7030.
D EFAULT DATA
5 7 1 B
CHANNEL ANY: YES
PRI MODE: DDI
DLSEND: OVERLAP
CLIP TABLE: 1
NB TYPE: UNKNOWN
NB PLAN: ISDN
CLIR w NUMB: OFF
2-136
When this option is set to ON, CLIP numbers are transmitted to the
network even though CLIP Restriction is set.
0. OFF
1. ON
When this option is set to OFF, ISDN port is searched by CONN ID and
if set to ON, searched by data channel id.
Specifies the called party's numbering plan as follows:
0. UNKNOWN
1. ISDN
2. NATION
Specifies the calling party's number type as follows:
0. UNKNOWN
1. INT. NAT
2. NATIONAL
3. NETWORK
4. SUBSCRIB
5. ABBREV
6. EXTEN
Determines the automatic update of the system time by the use of ISDN
Calls.
When this option is set to ON, the system time is updated if a correct
time value is transmitted from the trunk line.
Description
Samsung Business Communications
(continued)