709] Toll Pass Code/Special Code Table - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[ 709] TOLL PASS CODE/SPECIAL CODE TABLE

1 6 8 B
This MMC provides a means to program trunk code tables as described below.
No Special Code
0 PBX ACCESS CODE
1 SPECIAL CODE
2 TOLL OVERRIDE
3 OVRD USE TRK GRP
D EFAULT DATA
7 4 4 B
NONE
A CTION
7 4 5 B
1) Press Transfer button and enter 709.
Display shows:
2) Select PBX, SPECIAL CODE, TOLL OVERRIDE
or OVRD USE TRK GRP.
OR
Press Volume button to make selection and
press Right Soft button to move cursor.
3) Enter index number.(e.g., 3)
OR
Press Volume button to make selection and
press Right Soft button to move cursor.
2-224
This table contains up to five entries and is used to identify the
trunk access codes needed for toll restriction when the system
is used with either a PBX or a CENTREX-supplied dial tone. Toll
restriction will only be applied on trunks flagged as PBX in MMC
401 if a trunk access code entered in this table is dialled. Toll
restriction will be applied to the digits following the trunk access
code.
This table identifies the special feature codes used to activate
central office custom-calling features such as CID Block and
Call Waiting Disable. The special feature codes can be used on
a per-call basis without affecting LCR or toll restriction
programming. There is a maximum of 10 entries available, each
of which may be up to four digits long.
This table of eight entries is used to identify the numbers that
will bypass all dialling restrictions. This bypass includes toll
restriction, trunk access and forced authorization or account
codes. Each entry in the table can be up to 14 digits long.
This entry designates the trunk group that toll override calls will
access.
Description
DISPLAY
PBX ACCESS CODE
1:
TOLL OVERRIDE
1:
TOLL OVERRIDE
3:_
Samsung Business Communications