603] Assign Trunk Group - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[ 603] ASSIGN TRUNK GROUP

1 4 7 B
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is
useful in the programming of LCR when more than one trunk is to be in several dialling
plans. There are two different modes of operation: (1) sequential and (2) distribute. There
are 30 programmable trunk groups with up to 99 members per group. But in case of Of-
ficeServ 7100, it is possible to assign up to 60 members per group and there are 11 pro-
grammable trunk groups.
members per group and there are 5 programmable trunk groups.
Trunk group
One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
D EFAULT DATA
6 7 3 B
ALL LOOP/ISDN TRUNKS: 9
ALL TIE TRUNKS: 801
ALL VOIP NETWORKING TRUNKS: 803
ALL VOIP H.323 TRUNKS: 804
ALL VOIP SIP TRUNKS: 805
A CTION
6 7 4 B
1) Press Transfer button and enter 603.
Display shows:
2) Enter valid trunk group.(e.g., 9)
OR
Press Volume button to make selection and press
Right Soft button to advance cursor.
3) Press Right Soft button to change mode.
OR
Press Volume button to change mode to member.
4) Press Right Soft button to move cursor to number
of member and enter valid member number
(e.g., 05) via dial keypad.
OR
Press Volume button to make selection and press
Right Soft button to move cursor.
2-190
In case of OfficeServ 7030, it is possible to assign up to 8
(VOIP H.323 is not used in OfficeServ 7030)
(VOIP SIP TRUNKS : 802 in OfficeServ 7030)
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MEMBER 01:NONE
[9] TRK GROUP
MEMBER 05:NONE
Samsung Business Communications