Setting 8: Conveyor Application 2 - YASKAWA CIMR-VU BA0001 Technical Manual

No.
L8-07 Output Phase Loss Protection Selection
L8-38 Carrier Frequency Reduction
L8-41 High Current Alarm Selection
<1> Disable L8-05 for single-phase models.
No.
b1-01 Frequency Reference Selection 1
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-02 Carrier Frequency Selection
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
u

Setting 8: Conveyor Application 2

This setting is available in drive software versions PRG: 1020 and later.
No.
A1-02 Control Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Drive Duty Selection
L3-04 Stall Prevention Selection during Deceleration
n3-13 Overexcitation Deceleration Gain
n3-21 High-Slip Suppression Current Level
No.
A1-02 Control Method Selection
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
YASKAWA ELECTRIC SIEP C710606 18F YASKAWA AC Drive – V1000 Technical Manual
Parameter Name
Table 4.18 Preset 7: User Parameters (A2-01 to A2-16):
Parameter Name
Table 4.19 Conveyor 2: Parameters and Settings
Parameter Name
Table 4.20 Conveyor 2: User Parameters (A2-01 to A2-16):
Parameter Name
Default Setting
1: Triggered when a single phase is lost
1: Enabled below 6 Hz
1: Enabled (alarm output)
No. Parameter Name
d1-03 Frequency Reference 3
E2-01 Motor Rated Current
H1-05 Multi-Function Digital Input Terminal S5 Function
H1-06 Multi-Function Digital Input Terminal S6 Function
H2-01 Terminals MA, MB, and MC Function Selection
L1-01 Motor Overload Protection Selection
Default Setting
0: V/f Control
3.0 s
3.0 s
0: Heavy Duty
0: Disabled
1.4
150%
No. Parameter Name
E2-01 Motor Rated Current
L3-04 Stall Prevention Selection during Deceleration
n3-13 Overexcitation Deceleration Gain
n3-21 High-Slip Suppression Current Level
–
4.6 Application Selection
–
4
101