Device Range That Can Be Set - Mitsubishi Electric GOT2000 Connection Manual

11.6 Device Range that Can Be Set

The device ranges of controller that can be used for GOT
are as follows.
Note that the device ranges in the following tables are the
maximum values that can be set in GT Designer3.
The device specifications of controllers may differ
depending on the models, even though belonging to the
same series.
Please make the setting according to the specifications of
the controller actually used.
When a non-existent device or a device number outside
the range is set, other objects with correct device settings
may not be monitored.

Setting item
Item
Set the device name, device number, and bit number.
Device The bit number can be set only when specifying the bit of
word device.
Displays the device type and setting range which are
Information
selected in [Device].
Set the monitor target of the set device.
Select this item when writing data to all
controllers connected.
During monitoring, the controller which is set for
[Host Address] of the communication detail
settings is monitored.
All
(When inputting data with the numerical input
function, data is written to all the connected
controllers during input. The controller set for
[Host Address] is monitored during other than
Network
input (displaying).)
Select this item when monitoring the controller of
the specified station No.
After selecting, set the station No. of the
controller in the following range.
Station
1 to 99:
No.
100 to 115:
*1 The following shows the relation between station numbers of
the controller and the GOT data register.
Station
GOT data register (GD)
No.
100
101
:
114
115
Description
To monitor the controller of the
specified station No.
To specify the station No. of the
controller to be monitored by the
*1
value of GOT data register (GD).
Setting range
GD10 1 to 99
(If setting a value
GD11
outside the range
:
above, a device
GD24
range error
occurs.)
GD25
POINT POINT POINT
Device settings of CHINO controller
Devices are set with reference numbers.
For parameters corresponding to each reference
number, refer to the manual of the controller to be
used.
11.6.1 CHINO controller (CHINO
Controllers)
Device name
Digital parameter
(0)
Digital input data
*1
(1)
Analog input data
*1
(3)
Analog parameter
(4)
*1 Only reading is possible.
11. CONNECTION TO CHINO CONTROLLER
11.6 Device Range that Can Be Set
Device No.
Setting range
representation
00001 to 09999
Decimal
10001 to 19999
30001 to 39999
Decimal
40001 to 49999
11 - 31
11