Mitsubishi Electric GOT2000 Connection Manual page 189


GOT Ethernet setting
Make the settings according to the usage environment.
Item
Set the IP address of the GOT.
GOT IP Address
(Default: 192.168.0.18)
Set the subnet mask for the
sub network. (Only for
connection via router) If the
Subnet Mask
sub network is not used, the
default value is set.
(Default: 255.255.255.0)
Set the router address of the
default gateway where the
Default Gateway GOT is connected. (Only for
connection via router)
(Default: 0.0.0.0)
Set the GOT port No. for the
周辺 S/W 通信用ポー
S/W communication.
ト No.
(Default: 5015)
トランスペアレント用
Cannot be set
ポート No.
*1 By setting of the OMRON PLC, set the same [GOT
Communication Port No.] setting as that of [FINS UDP Port ]
of CX-Programmer.
Description Range
0.0.0.0 to
255.255.255.
255
0.0.0.0 to
255.255.255.
255
0.0.0.0 to
255.255.255.
255
1024 to 5010,
5014 to
65534
(Except for
5011, 5012,
5013 and
49153)
-

Ethernet setting
Item
The host is displayed. (The
Host host is indicated with an
asterisk (*).)
Set the network No. of the
N/W No. connected Ethernet module.
(Default: blank)
Set the station No. of the
PLC No. connected Ethernet module.
(Default: blank)
Type OMRON (fixed)
Set the IP address of the
IP Address connected Ethernet module.
(Default: blank)
Set the port No. of the
Port No. connected Ethernet module.
(Default: 9600)
Select a communication
Communication format
protocol. (Default: UDP)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
4. CONNECTION TO OMRON PLC
4.3 Ethernet Connection
Description Set value
-
1 to 127
1 to 254
OMRON
(fixed)
PLC side IP
address
256 to 65534
UDP, TCP
4 - 35
4