Connecting To Sdc20/21, Sdc30/31; Connecting To Cmc10L - Mitsubishi Electric GOT2000 Connection Manual

3.5.4 Connecting to SDC20/21,
SDC30/31

Communication settings
Make the communication settings by operating the key
of the temperature controller.
Item
*1
9600bps
Transmission speed
Data bit 8bits
Parity bit Disable
Stop bit 2bits
*2*3
0 to 127
Station address
*1 The transmission speed setting must be consistent with that
of the GOT side.
*2 Do not set to "0".
*3 Select the station address without overlapping with that of
other units.
3.5.5

Connecting to CMC10L


Communication settings
Make the communication settings by operating the DIP
switch of the Interface converter
Item
*1
Transmission speed
*2
Frame length
*1 The transmission speed setting must be consistent with that
of the GOT side.
*2 The sum of data length, parity bit and stop bit

Settings by switch
Front view of CMC10L body
3 - 52
3. CONNECTION TO AZBIL CONTROL EQUIPMENT
3.5 Control Equipment Side Setting
Set value
Set value
9600bps, 19200bps, 38400bps
9 to 15bits
DIP switch
Mode selector
switch
Rear view of CMC10L body
(1) Setting DIP switches
(a) Transmission speed settings
Switch No.
Transmission
speed (bps)
1 2
9600 ON OFF
19200 OFF ON
38400 ON ON
(b) Frame length settings
Switch No.
Frame length
4 5
8bits OFF OFF
9bits ON OFF
10bits OFF ON
11bits ON ON
12bits OFF OFF
13bits ON OFF
14bits OFF ON
15bits ON ON
(c) Connecting terminating resistors
Switch No.
Terminating
resistor
8
Enable ON
Disable OFF
(2) Mode selector switch settings
Set the switch to "TERMINAL".
3
Set these
switches
ON
ON
ON
6
OFF
OFF
Set these
OFF
switches
OFF
ON
ON
ON
ON
Set these
switches