Mitsubishi Electric GOT2000 Connection Manual page 227


GOT Ethernet setting
Item Description
GOT IP Set the IP address of the GOT.
Address (Default: 192.168.0.18)
Set the subnet mask for the sub
network. (Only for connection via
*1
router) If the sub network is not
Subnet Mask
used, the default value is set.
(Default: 255.255.255.0)
Set the router address of the
default gateway where the GOT is
Default
connected. (Only for connection
Gateway
via router)
(Default: 0.0.0.0)
Set the GOT port No. for the
周辺 S/W 通信
communication with the peripheral
用ポート No.
S/W. (Default: 5015)
トランスペア
レント用ポー
Cannot be set
ト No.

Ethernet setting
Range
0.0.0.0 to
255.255.255.255
0.0.0.0 to
255.255.255.255
Item
Host
0.0.0.0 to
255.255.255.255
N/W No.
1024 to 5010,
5014 to 65534
PLC No.
(Except for 5011,
5012, 5013 and
49153)
Type
-
IP Address
Port No.
Communication
POINT POINT POINT
(1) Communication interface setting by the Utility
(2) Precedence in communication settings
6. CONNECTION TO KEYENCE PLC
Description
The host is displayed. (The host is
indicated with an asterisk (*).)
Set the network No. of the
connected Ethernet module.
(Default: blank)
Set the station No. of the
connected Ethernet module.
(Default: blank)
KEYENCE (fixed)
Set the IP address of the
connected Ethernet module.
(Default: 192.168.0.10)
Set the port No. of the connected
Ethernet module.
(Default: 8501)
UDP, TCP
(Default: UDP)
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
6.3 Ethernet Connection
Set value
6
-
1 to 239
1 to 254
KEYENCE
(fixed)
PLC side IP
address
PLC side port
No.
Adjust the
settings with the
PLC settings.
6 - 17